Mold For Full Body Silicone Doll. Pour Your Own Silicone Babies And Make £££££££

Beautiful artist doll made from the scan of a real newborn. This listing is for a Full body silicone mold. NOT A FINISHED SILICONE DOLL. This mold comes with the full pouring rights.

Make and sell full body silicone babies without the sculpting or mold making knowledge. Included in the sale are. The full pouring rights to this mold.

Glove mold mixture to seal and repair glove mold where needed. Soft glove mold has slits on the arms and legs that need to be re sealed before pouring your doll (repair kit included). These were made to remove the hands and feet and to release them from the mold. You may have to repeat this process for each doll you make. General clear silicone filler is needed to seal the back opening before pouring the doll.

Once you have your mold. Apply 2 part moulding medium to the slits on the arms, legs and let cure. Once the have fully cured add silicone release agent to the inside of the mold making sure it is in all the crevices. Seal back seam with clear silicone (silicon from any DIY store is fine). Plane soft mold into hard outer mold and secure with elastic or bungee cords.

Place the entire mold upright into a bucket. Mix your silicone and pour inside the mold via the pour hole at the top.

Fill to 1cm up the pour hole. Open up the mold and check for any flaws. Paint of sell as a blank kit. Painted they can command a lot more.

I estimate this mold can make around 10 dolls.

---